|
|
1997 Ford Pickup 7.3L engine
cuts out going down the road & loses power after warmed up
almost dies then will run fine engine light comes on codes
[...] control panel excessive &1211 inj. control
pressuer |
View |
|
2001 Ford Crown Victoria 4.6L compressor
once i start the car the compressor comes on for 5 seconds
and then goes off because of the A/C cutwout relay, all the
wires going to the a/c cutout relay are ok , except for the
PINK/YELLOW coming from the PCM, when the car starts the
PCM output is ground for... |
View |
|
2001 Ford Explorer 4.0L suspension
hello all, I am stumped on this exploder in the shop. it
has a growling noise seeming to come from the right front
wheel. When you turn to the left the noise is there, when
you turn to the right the noise is gone. I replaced the
right wheel bearing, but no cha... |
View |
|
2001 Ford Taurus 3.0L Mechanical
This vehicle does not move forward or reverse. No fluid
pressure at either port on top of trans. Also, fluid level
does not drop when vehicle is started. I assume no pump
operation. Is there anything common in these. Maybe
stripped splines on shaft or is conve... |
View |
|
2002 Ford Pickup 5.4L some accessories stay on afeter key is out
The customer stated that after he turned off the ignition
the eatc, compass and door pad stayed on after removing the
key. After it sit for a while and these items went out the
headlights and parklights came on until the battery was
drained. I verified complia... |
View |
|
2003 Ford Explorer Sport 4.0L Air Bag Light
This vehicle came into our shop with the air bag light
illuminated. Pulled codes with Snap On 2500, found p2296
impact sensor circuit code, initially could not find any
specific information from Mitchell, source said code could
be any impact sensor (This vehic... |
View |
|
2004 Ford Pickup 5.4L No Start
Hello everyone, we have a head scratcher here. Around a
year ago fuel pump quit, had fuel pump replaced with
aftermarket unit at another shop,ran a while, pump quit
again, other shop replaced pump with oe unit. Ran several
months, came to us 2 months and 3000 ... |
View |
|
2005 Ford Crown Victoria 4.6L Alternator
Hello Fellow Members, My first time posting, so please
bear with me...Everything on this charging system test
normal...the alternator has been replaced and the battery .
.problem is that after a few weeks of driving back and
forth to work every day, the batter... |
View |
|
1993 Ford Aerostar 4.0L 4WD always on
New tires were tried first after the importance of matched tires was thoroughly explained to the owner. This did not change the symptom. Two of four replies were helpful. The system has proven to be quite reliable over the years so there is not alot of infor... |
4 |
|
1996 Ford F-Super Duty 7.3L Cuts out, Stall
First of all this is my first time using this forum. I truly appreciate everyone's help: Marty, Luke, Robert, and everyone else. I ended up driving the vehichle for a long period of time, a couple of hours very aggressively, and I finally got it to skip on t... |
12 |
|
1997 Ford Taurus 3.0L MIL Lamp on
I wanted to take the time to thank all who have replied to this matter, the problem was a corroded ground wire within the insulation, location was 3 inches from the connector at the solid state relay (ssr). System is now working normally. Trouble codes: P1413 (secondary air pump malfunction). |
3 |
|
1999 Ford Explorer 4.0L mil light for airbag
the diod under the seat was bad .25 to fix thanks guy most of you hit it on the head good job and thanks |
6 |
|
1999 Ford Ranger 3.0L Poor Fuel Economy, High Idle when cold
Got a lot of great, useful info, thanks to all. Nothing hit the nail on the head. Consensus was 4x4 6 cyl Rangers get lousy gas mileage and idle high (900 rpm).
It is dubious why Ford actually builds the Ranger when the 6 cylinders get the same lousy gas mi... |
13 |
|
2003 Ford Focus 2.0L fuel line retainer
I had the dealer run the vin and there were no updates on this one. I ended up threading a piece of .045 stainless wire through the slot for the retainer and then safety tying it as a back up. This was done with the retainer in place. The retainer still had o... |
3 |
|
Prev
